Panasonic PV-GS50-K Power Supply, Charging Time and Available Recording Time, Using the Battery

Models: PV-GS50 PV-GS50-K

1 220
Download 220 pages 13.57 Kb
Page 18
Image 18

1

1

2

3

PUSH

 

 

BATT 2

 

ON MODE

 

 

F

 

O

F

1

CGA-DU07 A

1 h 30 min.

B

2 h 15 min.

(1 h 35 min.)

CGA-DU14 A

2 h 45 min.

B

4 h 30 min.

(3 h 10 min.)

CGA-DU21 A

3 h 55 min.

B

6 h 45 min.

(4 h 45 min.)

Power Supply

ªUsing the AC Adaptor

1Insert the battery-shaped connector of the DC Cable into the Battery Holder on the Palmcorder.

2Connect the DC Cable to the [DC OUT] Jack on the AC Adaptor.

3Connect the AC Adaptor and AC Cable.

The AC Cable’s outlet plug cannot be pushed fully into the AC Adaptor Jack. A gap will remain as shown 1.

Before connecting or disconnecting the power supply, set the [OFF/ON/MODE] Switch on the Palmcorder to [OFF] and make sure that [CAMERA/VCR/CARD PB] Lamps are not lit.

Battery cannot be charged if DC Cable is connected to AC Adaptor.

ªUsing the Battery

Before use, fully charge the battery.

1Attach the Battery to AC Adaptor and charge it.

Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it.

The [POWER] Lamp and [CHARGE] Lamp lights up, and charging starts.

When the [CHARGE] Lamp goes off, charging is completed.

2Attach the charged Battery to the Palmcorder.

Disconnecting the Power Source

Set the [OFF/ON/MODE] Switch 1 to [OFF], and while pressing the [PUSH BATT] Button 2, slide the Battery or battery-shaped

connector upward to disconnect it.

When attaching or removing battery, set [OFF/ON/MODE]

Switch to [OFF] and make sure the Operation Mode Lamp is not lit.

When the Palmcorder is used for a long period of time, the Camera body becomes warm, but this is not a malfunction.

If the [CHARGE] Lamp does not light up, although the Battery is attached to the AC Adaptor, detach the Battery and reattach it.

~~~~~~~~~~~~~~~~~~~~~~

Charging Time and Available Recording Time

ACharging Time

BMaximum Continuous Recording Time

“2 h 15 min.” indicates 2 hour and 15 minutes. Battery CGA-DU07 is supplied.

The hours shown in the table are approximate hours.

The numeric characters in parentheses indicate the recording time when the LCD monitor is used. In actual use, the available

recording time may be shorter in some cases.

The hours shown in the table are for continuous recording at a temperature of 68xF (20xC) and humidity of 60%. If the Battery is charged at a higher or lower temperature, the charging time may be longer.

18

Page 18
Image 18
Panasonic PV-GS50-K Power Supply, Charging Time and Available Recording Time, Using the AC Adaptor, Using the Battery