Panasonic PV-GS50 Audio dubbing cannot be performed, Time Code becomes inaccurate, Disappears

Others

If you are experiencing one of the following problems with your Digital Palmcorder, it may be something you can correct yourself. Check the list below for Problems and Solutions.

Problems	Solutions
Audio dubbing cannot be performed.	≥Is the accidental erasure protection tab on the
	Cassette open? If it is open (set to [SAVE]),
	recording cannot be performed.
	≥Are you attempting to edit a tape portion that
	was recorded in LP Mode? LP Mode does not
	allow audio dubbing to operate.
The Time Code becomes inaccurate.	The Time Code Indication counter may not be
	constant in the reverse direction in Slow Motion
	Playback Mode, but this is not a malfunction.
The Remaining Tape Time Indication	When you record still pictures in PhotoShot
disappears.	Mode, the Remaining Tape Time Indication may
	disappear temporarily. However, it reappears
	when the Palmcorder is set back to Normal
	Recording Mode.
The Remaining Tape Time Indication does not	≥If scenes of less than 15 seconds are
match the actual remaining tape time.	continuously recorded, the remaining tape time
	cannot be displayed correctly.
	≥In some cases, the Remaining Tape Time
	Indication may show remaining tape time that
	is 2 to 3 minutes shorter than the actual
	remaining tape time.
Video cannot be played back even when the	Is the [VCR] Lamp on? If the [VCR] Lamp is not
[1] Button is pressed.	on, the playback function cannot be used.
Mosaic-like noise patterns appear on images	This phenomenon is characteristic of digital
during Cue, Review or Slow Motion Playback.	video systems. It is not a malfunction.
Although the Palmcorder is correctly	Have you selected Video Input on the TV?
connected to a TV, playback images cannot be	Please read the operating instructions of your
seen.	TV and select the input that matches the input
	jacks used for the connection.
Playback image is not clear.	Are the heads of the Palmcorder dirty? If the
	heads are dirty, playback image will not be clear.
No sound is played back from the built-in	Is the volume too low? During playback,
speaker or headphones of the Palmcorder.	continue pressing the [PUSH] Dial until the
	[VOLUME] Indication appears. Then, rotate the
	[PUSH] Dial to adjust the volume.
Different sounds are reproduced at the same	[12bit AUDIO] on the [PLAYBACK FUNCTIONS]
time.	Sub-Menu of the [VCR FUNCTIONS] Main-
	Menu has been set to [MIX]. As a result, the
	original sound and sound that was recorded by
	audio dubbing are played back together. It is
	possible to reproduce the sounds separately.

101