Panasonic WV-SC380, WV-ST160, WV-SW170, WV-SW390 13.5 Configure the settings relating to the alarm output terminal [Alarm]

H.264 recording (SD memory card)
[Pre alarm]
Determine whether or not to perform the pre alarm recording. When “Use” is selected, 1 MB image data is
always saved during the pre alarm recording.
Use/ Not use
•Default: Not use
[Post alarm (recording) duration]
Set the duration to save image data on the SD memory card after an alarm occurrence.
10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s
•Default: 30s
* The actual recording time may sometimes be longer than the duration selected for this setting.
[Recording (memory) size per an alarm]
The capacity of the SD memory card used to record video data upon an alarm occurrence. The actual capacity
may be different.
IMPORTANT
•To record H.264 data, it is required to select “Use” for “SD memory card” on the [SD memory card] tab.
In addition, it is required to select “H.264” for “Recording format”. (®page 58)
13.5 Configure the settings relating to the alarm
output terminal [Alarm]
Click the [Alarm] tab on the “Alarm” page. (®page 47, page 49)
The settings relating to the alarm output terminal can be configured in this section.
Alarm output terminal setup
[Alarm output trigger]
Select “On” or “Off” to determine whether or not to output the alarm signals to the alarm output terminal when
an alarm is detected.
•Default: Off
[Alarm output type]
Select “Latch” or “Pulse” for the alarm output terminal at an alarm occurrence.
•Latch: When an alarm is detected, the alarm output terminal will be in the state selected for “Trigger
output” until the alarm occurrence indication button is clicked.
Operating Instructions 141
13 Configure the alarm settings [Alarm]