Panasonic WV-SC380, WV-ST160, WV-SW170, WV-SW390 ,

•When “360 map-shot” is carried out while the camera is moving (panning/tilting), images captured

while panning/tilting may be displayed as the thumbnail display. In this case, stop the current

operation and carry out “360 map-shot” again.

•When “Preset map-shot” is carried out with an unregistered preset position (among preset position

1-8), the thumbnail image of the preset position before the unregistered preset position will be

displayed.

In this case, the camera will not move when the thumbnail image is clicked.

•The camera will not always return to the exactly same position where it was before “360

map-shot” or “Preset map-shot” was carried out. (It may sometimes be slightly different.)

•The window on which the thumbnail images are displayed will close when clicking the following

buttons that can switch the camera channel or reload images: [Live], [Multi-screen], [H.264],

[MPEG-4], [JPEG], [Stream], [Image capture size], [Image quality], [Setup].

To display the thumbnail images again, carry out “360 map-shot” or “Preset map-shot” again.

•Patrol 1-4

SW396

SC386

: Performs patrols 1-4 that were set in advance. (®page 118)

Control pad/buttons*4

•: Left-click on the control pad to adjust the horizontal/vertical position of the camera

(panning/tilting). Panning/tilting speed will be faster if a clicked point gets farther from the center point

of the control pad.

SW396

SW395

SC386

SC385

SC384

It is also possible to pan/tilt the camera by dragging the mouse.

Zoom and focus can be adjusted by right-clicking. When an upper/lower area of the control pad is

right-clicked, the displayed image will be zoomed in/out on. When a left/right area is right-clicked, the

focus will be adjusted to the Near/Far side.

Zoom can also be adjusted using the mouse wheel.

SW175

SW174W

SW172

ST165

ST162

It is also possible to pan/tilt the camera by dragging the mouse.

Zoom can be adjusted by right-clicking. When an upper/lower area of the control pad is right-clicked,

the displayed image will be zoomed in/out on.

Zoom can also be adjusted using the mouse wheel.

[Brightness] buttons*4

Available range: 0 - 255

• button: The displayed image will be darker.

• button: The adjusted brightness will return to the default brightness (64).

• button: Image will be brighter.

[Preset]*4

Select a preset position from the pull-down menu and click the [Go] button. The camera will move to the

selected preset position (®page 113). “H” next to the preset position number indicates the home position.

When “Home position” is selected, the camera will move to the home position. (®page 94) When “Preset

ID” is registered for a preset position, the registered preset ID will be displayed next to the preset position

number.

Camera title

The camera title entered for “Camera title” on the [Basic] tab will be displayed. (®page 53)

Alarm occurrence indication button*4

This button will be displayed and will blink when an alarm has occurred. When this button is clicked, the

alarm output terminal will be reset and this button will disappear. (®page 33)

16 Operating Instructions

1 Monitor images on a PC