The description below is the configuration of the priority stream that can transmit images without deteriorating
the image quality and refresh interval even when multiple users access concurrently.
Priority stream[Activation]
Select “On” or “Off” to determine whether or not to use the priority stream.
•Default: Off
Note
•When “On” is selected for “Activation” of “Priority stream”, number of users who can access the camera
may be limited.
[Destination IP address(1)]
Enter the first destination IP address.
[Destination IP address(2)]
Enter the second destination IP address.
[Stream type]
Select either “JPEG”, “H.264/MPEG-4(1)” or “H.264/MPEG-4(2)”.
•JPEG: JPEG images will be transmitted.
•H.264/MPEG-4(1): H.264(1) (or MPEG-4(1)) images will be transmitted.
•H.264/MPEG-4(2): H.264(2) (or MPEG-4(2)) images will be transmitted.
•Default: JPEG
Note
•When “Best effort” is selected for “Transmission priority” of “H.264 (MPEG-4)”, bit rate will vary between
the maximum and minimum rates while images are being transmitted.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW172
SW172
ST165
ST165
ST162
ST162
:
•When “H.264” is selected for “Recording format”, it is impossible to transmit H.264(2) images. In this
case, “H.264/MPEG-4(2)” is invalidated.
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when “JPEG” is selected for “Stream type”.
SW395
SW395
SC385
SC385
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps/ 10fps/ 12fps*/ 15fps*/ 30fps*
Operating Instructions 159
15 Configure the settings relating to the authentication [User mng.]