Appendix a, Clocking Modes, DTE Rate | Patton electronic 3088

APPENDIX A

SPECIFICATIONS

A.1 CLOCKING MODES

Internal, external (V.35 only), or receive recovered

A.2 DTE RATE

All 64k steps from 64 to 4608 kbps

A.3 SERIAL INTERFACE

V.35 (Model 3088/CA), DCE orientation;

X.21 (Model 3088/D), DCE or DTE orientation depending on orientation of daughter board mounted on the mother board.

A.4 SERIAL CONNECTOR

D-Sub-25 Female (Model 3088/CA)

D-Sub-15 Female (Model 3088/D)

A.5 DIAGNOSTICS

V.52 compliant (511/511E) pattern generator and detector with error injection mode controlled by front-panel switch. Local and Remote Loop- back control either by a front-panel switch or from the DTE interface.

A.6 STATUS LEDS

Power (Green)

The Power LED glows solid during normal operation. At startup, during the POST, the LED blinks once every second. If the POST fails, the unit does not enter normal operation, and the LED blinks once every

0.4 seconds.

DSL (Green)

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

43

Image 43

Patton electronic 3088 user manual Appendix a, Clocking Modes, DTE Rate, Serial Connector, Diagnostics, Status Leds

Contents

User Manual Contents Remote Console Manual Information Operation FCC Part 68 Acta Statement Compliance Information Radio and TV Interference CE Notice Industry Canada Notice Service Warranty InformationTel +1 301 Email support@patton.com General Information FeaturesDescription Model 3088 3088/D version shown Configuration Parameter Description Possible Default Values OFF, LAL Configuring the DIP Switches Parameter Description Possible Default Software Upgrades System Reset Mode DIP Switch Settings Conﬁguration Reset to Factory DefaultsPosition Function Factory Default S1-7 S1-1 Data Rate S1-8 TX Clock Setting DescriptionS1-7 S1-6 S1-5 S1-4 S1-3 S1-2 S1-1 Data Rate Kbps 1920 Loops S2-6 SettingS2-5 S2-4 Clock Mode S2-5 S2-4 Clock Mode Description S2-2 Line Probe S2-1 Front Panel SwitchesS2-3 Annex A/B S2-3 AnnexPage CRC DSL Line Condition Good or Poor System Conﬁguration Commands Help Commands System Status Commands System show clockmode Shows the clock mode Startup Delay Interval Interval totint DSL Conﬁguration Commands DSL Status Commands Page Remote Console Example Command Line Interface Session Rocketlink Plug ‘N’ Play 3096RC Connecting the Twisted Pair Interface Installation Connecting the Model 3088/CA V.35 to a DTE Device Connecting the Model 3088/CA Serial Interface Connecting the Model 3088/D X.21 Serial Interface Connecting the Model 3088/CA V.35 to a DCE DeviceConnecting the Model 3088/D X.21 to a DCE or DTE Device Opening the Case Connecting the Model 3088/D to X.21 DTE or DCE Connecting Power LED Status Monitors POWER-UPPower Green Operation Test Modes Term Green3088/D with the X.21 interface TM/ER Red Patterns Local Analog Loopback diagram Remote Console Manual Information How to ConnectEstablishing a Remote Console Session Page How to Disconnect System show status command shows that DSL link is not up Differences in Local and Remote Control Session Behavior LAL Model 3088 Software Upgrade Feature Reset Configuration to Factory Defaults Clocking Modes Serial ConnectorDiagnostics Appendix a Line Coding PowerCompliance Transmission Line 14 G.SHDSL Physical Connection Line InterfaceEnvironment Model # Description Appendix B Appendix C Pin # Signal Appendix D Pin Signal