Paxar 917 manual E d M o d e, I n t P o s i t i o n, Supply Type

F e e d M o d e

You can use continuous or on-demand printing. On-demand printing allows you to remove a label before printing the next one.

To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these steps.

1.Press L or R until you see

SUPPLY

l Feed Mode r

2.Press E to set the supply type option. You will see the current setting, for example:

SUPPLY TYPE

Continuous r

3.Press L or R to see the other option. After you display the option you want, press E. Press e twice to exit to the Main menu.

P r i n t P o s i t i o n

This function adjusts where data prints vertically on the supply. Adjust the print if it is too close to the top or bottom of the supply, or overtypes the pre-printed area. One dot is 0.0049 inch.

uIf the data is too close to the bottom, increase the number.

uIf the data is too close to the top, decrease the number.

Changing this setting only affects new

formats sent to the printer.

2-4Setting Supply Options