EN
Switch on the Flash Function for the Extension
For older telephone systems, the outside line access code can be R (= FLASH). Only in this setting can a connection to the public telephone network be made. With the flash function switched on, a flash signal is triggered with the R key.
Notice
Outside Line Access Code is Automati- cally Dialled
Store telephone numbers in the telephone book at the beginning using R to automatically estab- lish a connection to the public telephone net- work. By pressing the R key, E appears on the display.
1Press MENU. RECEPT.
2Select using [ INSTALLATION.
3Confirm with o. STATION NAME appears on the display.
4Select using [ TEL.LINE SETUP.
5Confirm with o. LINE TYPE appears on the display.
6Select using [ PBX FLASH.
7Confirm with o.
8Using [ select whether by pressing the R key, a flash signal should be triggered or not.
9Confirm with o.
Connecting Additional Devices
You can operate additional devices on a telephone line, such as cordless telephones, answering machines, modems or charge counters.
Connection to the Device
You can connect additional devices directly to your device.
1Insert the telephone cable of the additional device into the EXT socket
Connection to the Telephone Line
In order for the fax switch to function, the device must be first in the series if multiple devices are connected to the same telephone socket. Follow the correct order.
Notice
Connection to the First Telephone
Socket
If you have multiple telephone sockets for the same telephone line, the device must be con- nected to the first telephone socket.
Using Additional Telephones (Easylink)
With the Easylink function you can control your device with additional telephones. To use this function, addi- tional telephones must be set to the tone dialling mode (DTMF/MFV tones) (for this purpose see the operating manual of your additional telephone).
Starting Fax Reception
If you pick up at an additional device and hear that you are receiving a fax (whistling tone or silence), you can start the fax reception by pressing ** on the additional tele- phone.
Changing Code
CAUTION!
Changing Easylink Codes!
Change the code only if it is absolutely neces- sary. The code must begin with * or # .
1Press MENU. RECEPT.
2Select using [ INSTALLATION.
3Confirm with o. STATION NAME appears on the display.
4Select using [ TEL.LINE SETUP.
5Confirm with o. LINE TYPE appears on the display.
6Using [ select REMOTE CONTROL.
7Confirm with o.
8Using [ select YES.
9Confirm with o.
10 Enter the new code for starting fax reception.
11 Confirm with o.
12 You can exit with j.
Notice
Switching Off Function
You can switch this function off, if in step 8 you select NO, confirm using oand exit using j.
34 | Philips · IPF 520 · 525 · 555 |
