Philips M1351A, M1353A manual Chassis

Chassis

Chassis

To remove the chassis:

1.Remove the top cover.

2.Remove the combined interface board - if installed.

3.Remove the Front End Board.

4.Remove the six screws (S).

5.Remove the nut from the Earth Grounding Point.

6.Lift out the chassis.

To refit the chassis, reverse the above procedure. Remember to feed the cable from the rear display board through the slot in the back of the chassis. After refitting the chassis, carry out the Parameter Test (see page 68).

Chapter 11 Replacing Parts 143