Philips M1351A, M1353A manual 12Refitting the Recorder Board

Recorder Board

Recorder Board

To remove the recorder board:

Remove the top cover.

1.Disconnect the cables G, H, I, K, and L.

2.Remove the three screws (1 x S1, 2 x S2). The S2 screws are longer than the S1 screw.

3.Remove the cable J.

4.Lift out the board.

To refit the recorder board:

1.Slide the board into the slot. To give a good electrical contact, the board is tensioned when screwed down.

2.Refit the screws and screw down the board.

Figure 11-12Refitting the Recorder Board

After refitting the board, carry out the Parameter Test (see page 68).

Chapter 11 Replacing Parts 145