Philips M1351A, M1353A manual List of Parts, Troubleshooting and Error Messages

List of Parts

Programming a 1. Scan the “Start Modem Setup” barcode.

Modem Setup

Sequence 2. Use the barcodes to enter the setup according to the operating manual of the modem you are using.

Permanently

Storing a Modem

Setup Sequence

3.Scan “Finish Modem Setup” to enter the modem setup you have just programmed.

4.Check the operation of the setup by using the codes on the Patient Identification barcode sheet.

Scan the following barcodes, in the order given below:

1.Start Modem Setup

2.Store Settings

3.Finish Modem Setup

To erase your custom setup, and restore the factory setting, scan Recall Factory Setting of Modem.

List of Parts

Description	Part Number
Interface Board	M1353-69532
Barcode Overlay	M1353-44312
Cable Fasteners (x4 at 20cm)	1400-0507
Velcro-Type Strip (20cm)	0570-0634

Troubleshooting and Error Messages

All the standard fetal monitor error messages listed in “Operator Error Messages” on page 69 remain the same once the modem interface module option has been added. The additional error messages unique to this option are:

1.Err 70 PCMCIA card modem not responding, accompanied by three tones (displayed nfor 10 seconds).

The Modem is either incorrectly installed, faulty or not an approved model.

Appendix A Modem Interface Module 165