| English 15 |
| |
Frequently asked questions | |
Question | Answer |
|
|
Why does the baby monitor | The specified range is only valid outdoors in open air. Inside your |
have a smaller operating | home, the workable range is limited by the number and type of |
range than the 200 | walls and/or ceilings between the baby unit and the parent unit. |
meters/600 feet mentioned | The maximum operating range inside your home is 50 |
under ‘Operating range’? | meters/150 feet. |
Why is the connection lost | The parent unit is probably close to the boundaries of the |
every now and then? | operating range. Put the parent unit closer to the baby unit in a |
| place where it has a better reception. Please note that it takes |
| about 30 seconds before connection is |
| move one or both units. |
What happens if there is a | If you have placed batteries in the baby unit, the baby |
power supply failure? | unit switches to battery operation. If the battery pack of the |
| parent unit is sufficiently charged, the parent unit starts to run on |
| battery power. |
Why does the parent unit not work even though it is placed in the charger?
Why can I not use the parent unit cordlessly for 12 hours on a fully charged new battery pack?
Why does the parent unit run less than 12 hours on a full charge?
Why do the power light and the display of the baby unit not go on when I press the POWER button?
When the battery pack of the parent unit is low, you have to charge it for up to 20 minutes before you can operate the parent unit on mains power.
You have to charge and discharge a new battery pack three times before it reaches its full capacity.
Perhaps the volume is set too high. When the volume is set to a high level, the parent unit consumes more power. Set the volume to a lower level.
A battery pack that has been in use for quite some time gradually loses its capacity. When this happens, you get fewer running hours on a full charge.
If you start to use the parent unit again after some time, the battery pack may have lost some of its charge. Place the parent unit in the charger to recharge the battery pack.
The batteries are empty. Replace the batteries.
You have not plugged in the baby unit. Insert the small plug in the socket on the baby unit and insert the adapter in the wall socket.
Why does the battery empty The batteries are low. Replace the batteries. symbol on the display of the
baby unit light up and why does the power light blink?
Why do the batteries of the baby unit run out so quickly?
Perhaps you have set the microphone sensitivity level too high. Set the microphone sensitivity to a lower level.
