Pioneer AVIC-Z1 Changing the measure for dis- play, Checking the Setting Related, with Hardware

AZERTY:

Changing the measure for dis- play

This setting controls the unit of distance dis- played on your navigation system.

1 Touch [Settings] in the navigation menu, then touch [Regional Settings].

2 Touch [km / mile] to change the setting. Each time you touch the key changes that set- ting.

mile*:

Checking the Setting Related
with Hardware	NAVI

The hardware status, including the driving status of a vehicle, positioning status by satellite, learn- ing status of the 3D sensor, and cable connection status etc., can be checked.

Checking the connections of leads and installation positions

Check that leads are properly connected between the navigation system and the vehicle. Please also check whether they are connected in the correct positions.

1 Touch [Settings] in the navigation menu, then touch [Hardware].

Show distance in miles. Mile & Yard:

Show distance in miles and yards. km:

Show distance in kilometers.

Changing the virtual speed of

2 Touch [Connection Status].

The Connection Status screen appears.

(1)

(2)

(3)

(4)

(5)

(6)

Chapter 10

vehicle

When calculating expected time of arrival and the number of hours to the destination, set the aver- age speed for the freeway or ordinary roads using [+] and [–].

1 Touch [Settings] in the navigation menu, then touch [Regional Settings].

2 Touch [Average Speed].

3 Touch [+] or [–] to set their speed.

❒The estimated time of arrival is not neces- sarily estimated based on this speed value.

	(7)	Modifying
	(8)
(1) Speed Pulse
The Speed Pulse value detected by the naviga-		the
tion system is shown. [0] is shown while the
		General
(2) GPS Antenna
vehicle is stationary.		Settings
how many satellites the signal is received. If
Indicates the connection status of the GPS
antenna, the reception sensitivity, and from
the signal is received correctly, [OK] is dis-		for
played. If reception is poor, [NOK] appears. In		Navigation
such case, please change the installation
position of the GPS antenna.
(3) Phone Connection Status		Functions
phone. If the connection of Bluetooth unit is
Indicates the connection status of the Blue-
tooth unit and the signal strength of cellular
correctly, [OK] is displayed. [NOK] appears
when the Bluetooth unit is not connected or
incorrectly connected.

❒Signal strength may differ from the actual signal strength on the cellular phone.

93