Pioneer AVIC-Z1 Indication of the position of your vehi, nected properly. The navigation sys

Symptom	Cause	Action (See)
	Signals from the vehicle’s speed	Check that the cables are properly
	pulse are not being picked up prop-	connected. If necessary, consult the
	erly.	dealer that installed the system.
	The navigation system may not be	Check that the navigation system is
	mounted securely in your vehicle.	securely mounted and, if necessary,
		consult the dealer that installed the
		system.
	Your vehicle is operating in Simple	Connect the speed signal input (pink
	hybrid mode.	lead wire) of the power cable cor-
		rectly, and reset the 3D Hybrid Sen-
		sor memory ([Learning Status]).
	The navigation system is installed	Confirm the installation angle. (The
	with an extreme angle exceeding the	navigation system must be installed
	limitation of the installation angle.	within the allowed installation angle.
		For details, refer to “Installation Man-
		ual” and [Installation Angle Setup]
		on page 94.)
	Indication of the position of your vehi-	Check whether or not the reverse
	cle is misaligned after a U-turn or	gear signal input lead (purple) is con-
	reversing.	nected properly. (The navigation sys-
		tem works properly without the lead
		connected, but positioning accuracy
		will be adversely affected.)
The map continually reorients itself.	The traveling direction is always set	Touch	on the screen and change
	to Heading Up.	the map display.
The daylight display is used even	[Daytime] is selected to [Day/Night	Check the [Day/Night Display] set-
when the vehicle lights are on.	Display].	ting (➞ Page 49) and make sure
		[Automatic] is selected.
	The orange/white lead is not con-	Check the connection.
	nected.
The display is very dim.	The vehicle’s light is turned ON, and	Read about the [Day/Night Dis-
	[Nighttime] is selected on [Day/	play] setting (➞ Page 49) and, if
	Night Display].	desired, select [Daytime].
	The vehicle cabin temperature is	A Liquid Crystal Display (LCD) is
	extremely low.	used, and such displays tend to
		darken when cold. Wait for the vehi-
		cle to warm up.
	Picture quality adjustment of the dis-	Refer to “Operating the Picture
	play is not correct.	Adjustment” (➞ Page 158) to adjust
		the picture quality.
	Display tilt is not proper setting.	Press and hold EJECT button to
		adjust the tilt.
No sounds are heard.	The volume level is low.	Adjust the volume level.
The volume level will not rise.
	The attenuator or mute is on.	Turn the attenuator or mute off.
	The speaker lead is disconnected.	Check the connection.
Volume of beeps and navigation	You cannot adjust these parameters	Turn the volume up or down with
guidance cannot be adjusted.	with the VOL (￿/￿) button.	[Volume] in the [Settings] menu.
Adjusting the volume of navigation	You cannot adjust them with the	Turn the volume up or down accord-
guidance and beep is not possible.	VOL (￿/￿) button.	ing to [Volume] (➞ Page 91) in the
		Settings menu.
A strange sound is heard when the	The sound for the registered location	Set the sound of that registered loca-
vehicle comes close to a certain	is set.	tion to [No Sound]. (➞ Page 64)
place. (E.g. Dog barking)
Slope is not displayed on the Vehi-	The speed pulse lead is not con-	Connect the speed pulse lead.
cle Dynamics screen. Inclination	nected.
does not move on the 3D Calibra-
tion screen.

NAVI/AV

Appendix

185