Pioneer AVIC-Z1 operation manual 188, Message When What to do

NAVI/AV

Messages and How to React to Them

Messages for navigation functions

The following messages may be displayed by your navigation system.

❒There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display.

Message	When	What to do
Irregular speed pulse signal	If the navigation system does not	Consult your Pioneer dealer.
detected. Please power off the sys-	receive the vehicle speed pulse.
tem and check the installation. Then,
please re-boot the system and press
“OK”.

Speed pulse not connected. Calibra- tion will start without speed pulse. Accuracy is not fully ensured without speed pulse.

The speed signal input (pink lead wire) of the power cable is not con- nected.

To operate with 3D hybrid mode, con- nect the speed signal input (pink lead wire) of the power cable cor- rectly.

Although it can be operated with Simple hybrid mode without con- necting the speed signal input, the precision of the positioning will be less accurate.

Appendix

Vibration detected. Please power off	The navigation unit is installed in a	Re-install the navigation unit in a
the system and check the installa-	place where it may be affected by a	place where the unit will not be
tion. Then, please re-boot the system	large vibration.	affected by vibration.
and press “OK”.
Direction of G sensor is not correct.	Direction of G sensor is set incor-	See the Installation Manual and set
Please power off the system and	rectly.	the direction of the navigation unit
check the installation. Then, please		correctly.
re-boot the system and press “OK”.
Gyro Sensor is not working properly.	Abnormal output of Gyrosensor is	Note down the error code shown on
Please consult your dealer or Pioneer	detected.	the screen; turn off the power, and
service center.		then contact your nearest Pioneer
		service facility.
Positioning is not possible due to the	The location display is not possible	Consult your dealer.
hardware. Please contact your dealer	due to failure of hardware.
or Pioneer service center.
GPS antenna problem detected.	The location display is not possible	Consult your dealer.
Please contact your dealer or Pioneer	due to failure of GPS antenna.
service center.
This function is not available now.	The screen cannot be displayed with	If the sensor learning status reaches
	Vehicle Dynamics Display.	the Sensor Initializing status or more,
	Because the sensor has not been	the system is ready to be used.
	taught so the sensor information
	cannot be acquired.
The vertical installation angle is	If the mounting angle of the Hide-	The system initializes the sensor in
changed. Gyro Sensor calibration is	away unit has been changed.	order to operate it with the maximum
re-initialized.		performance and automatically
		starts re-learning.
Excess vertical installation angle	The navigation system is installed	Confirm the installation angle. (The
detected. Please install the naviga-	with an extreme angle exceeding the	navigation system must be installed
tion unit correctly.	limitation of the installation angle.	within the allowed installation angle.
		For details, refer to Installation Man-
		ual.)
No data available at this time.	If no data is available that can be	Wait for a while and try the operation
	used with the XM tuner.	again.
“UPDATING” is displayed at the right	Radio is being updated with the lat-	Wait until the encryption code is fully
corner on the map	est encryption code.	updated.

188