Pioneer AVIC-Z1 operation manual Checking sensor learning status and driving status

NAVI

Chapter 10

Modifying the General Settings for Navigation Functions

❒Depending on the cellular phones featur- ing Bluetooth technology, signal strength

is not available.

(4) Installation Position

The installation position of the navigation sys- tem is shown. That indicates whether the installation position of the navigation system is correct or not. If installed correctly, [OK] appears. When the navigation system is installed at an extreme angle exceeding the limitation of the installing angle, [Incorrect angle] will be displayed. When the angle of the navigation system has been changed, [Excessive vibration] will be displayed.

(5) Parking Brake

When the parking brake is applied, [On] is dis- played. When the parking brake is released, [Off] is displayed.

(6) Power Voltage

The power voltage (reference value) provided from the vehicle battery to the navigation sys- tem is shown. If the voltage goes out of the range from 11 to 15V, check that power cable connection is correct.

(7) Illumination

When the headlights or small lamps of a vehi- cle are on, [On] is displayed. Small lamps of a vehicle are off, [Off] is displayed. (If the orange/ white lead is not connected, [Off] appears.)

(8) Back Signal

When the gear lever is shifted to [R], the sig- nal switches to [High] or [Low]. (Either of these is displayed depending on the vehicle.)

Checking sensor learning status and driving status

1 Touch [Settings] in the navigation menu, then touch [Hardware].

2 Touch [3D Calibration Status].

The 3D Calibration Status screen appears.

(5)	(4)
(6)
(7)	(1)
	(2)
	(3)

(1) Distance

Driving distance is indicated.

(2) Speed Pulse

Total number of speed pulses is indicated.

(3) Learning Status

Current driving mode is indicated.

(4) Degree of learning

Sensor learning situations of distance (Dis- tance), right turn (Right Turn), left turn (Left Turn), and 3D detection (3D) are indicated by the length of bars.

❒When tires have been changed or chains fitted, turning on the Speed Pulse allows the system detects the fact that the tire diameter has changed, and automatically replaces the value for calculating distance.

❒If the ND-PG1 is connected, the distance

calculation value cannot be replaced auto- matically.

(5) Speed

Speed detected by the navigation system is indicated. (This indication may be different from the actual speed of your vehicle, so please do not use this instead of the speedom- eter of your vehicle.)

(6)Acceleration or deceleration/Rota- tional speed

Acceleration or deceleration velocity of your vehicle is indicated. Also, rotational speed when your vehicle turns to left or right is shown.

(7)Inclination

Degree of slope of the street is indicated.

94