Pioneer DEH-P7100BT Initial Settings Switching the dimmer setting, Adjusting the brightness

Section
11		Initial Settings
	Switching the dimmer setting		1 Display the initial setting menu.
	To prevent the display from being too bright at		Refer to Adjusting initial settings on page 48.
	night, the display is automatically dimmed		2 Use MULTI-CONTROL to select
	when the car’s headlights are turned on. You		S/W control in the initial setting menu.
	can turn the dimmer on or off.		3 Press MULTI-CONTROL to switch the
	1 Display the initial setting menu.
			rear output setting.
	Refer to Adjusting initial settings on page 48.		Pressing MULTI-CONTROL will switch be-
	2 Use MULTI-CONTROL to select Dimmer		tween Rear SP :F.Range (full-range speaker)
			and Rear SP :S/W (subwoofer) and that status
	in the initial setting menu.
			will be displayed.
	3 Press MULTI-CONTROL to turn dimmer		# When no subwoofer is connected to the rear
			output, select Rear SP :F.Range (full-range speak-
	on.
			er).
	# To turn dimmer off, press MULTI-CONTROL
			# When a subwoofer is connected to the rear
	again.
			output, select Rear SP :S/W (subwoofer).
	Adjusting the brightness		Notes
			! Even if you change this setting, there is no
	You can adjust the display brightness.
			output unless you turn the subwoofer output
	1 Display the initial setting menu.		on (refer to Using subwoofer output on page
			45).
	Refer to Adjusting initial settings on page 48.
			! If you change this setting, subwoofer output
	2 Use MULTI-CONTROL to select		in the audio menu will return to the factory
	Brightness in the initial setting menu.		settings.
	3 Push MULTI-CONTROL left or right to		! Both rear speaker lead outputs and RCA rear
			output are switched simultaneously in this
	adjust the brightness level.
			setting.
	0 to 15 is displayed as the level is increased or
	decreased.
	# When dimmer is functioning, the brightness		Switching the feature demo
	level can be adjusted 0 to 10.

Setting the rear output and subwoofer output

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (Rear SP :F.Range) or subwoo- fer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (Rear SP :F.Range).

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Display the initial setting menu. Refer to Adjusting initial settings on page 48.

2Use MULTI-CONTROL to select Demonstration in the initial setting menu.

3Press MULTI-CONTROL to turn the fea-

ture demo on.

# To turn the feature demo off, press MULTI-CONTROL again.

50 En