Basic connections, Connecting the antenna

05Preparation

Preventing the plasma display from falling over

After installing the stand, be sure to take special care to ensure that the plasma display will not fall over.

Stabilizing on a table or floor

Stabilize the plasma display as shown in the diagram using screws that are available on the market.

Note

•To stabilize the plasma display on a table or on the floor, use screws that have a nominal diameter of 6 mm and that are at least 20 mm long.

15 mm	6 mm
9 mm to	20 mm min.
	20 mm min.

Caution

•A table or an area of the floor with adequate strength should always be used to support the plasma display. Failure to do so could result in personal injury and physical damage.

•When installing the plasma display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents.

•If you do not take these precautions, the plasma display could fall down and cause injury.

•The screws, hooks, chains and other fittings that you use to secure the plasma display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached.

•Select the appropriate screws, hooks, chains, and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary.

Using a wall for stabilization

1Attach falling prevention bolts (hooks) to the plasma display.

2Use strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element.

Perform this work in the same way on the left and right sides.

Use hooks, cords and fittings that are available on the market. Recommended hook: Nominal diameter 8 mm Length 12 mm to 15 mm.

12 mm to 15 mm

1. Hook

2. Cord

Fitting