Preparation | 05 |
Antenna cable (commercially available)
If your outdoor antenna uses a
Note
•If the antenna is not connected correctly, the quality of reception may be impaired. If images are not displaying correctly, check whether the antenna connection is correct or not.
Tidying the speaker cables (PDP-507XG only)
Use the supplied bead bands as necessary to tidy the speaker cables.
Speaker cables
Bead band
English
Routing cables
Use the speed clamps as necessary to route the connecting cables. The diagrams below show the location of the holes on the rear of the display.
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable.
1
2 3
4
Ferrite core
Cable tie
To power outlet
AC power cord
As close as possible
Note
•Disconnect the power cord from the power outlet when the plasma display is not going to be used for a long period of time.
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma display and snap [2] into the back of [1] to lock the clamp.
2
1
•Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.
•Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed.
•Be careful not to subject any connecting cables to strain.
Connecting the power cord
Power cord 
To power outlet
17
En
