Pioneer PDP-507XG, PDP-427XG manual Watching TV Chapter, Turning the power on

Watching TV

Chapter 6

Watching TV

Important

•Before watching broadcast channels, the built-in TV tuner must be set up. See Setting up TV channels automatically on page 25 for how to do this.

Turning the power on

•To turn on the system, press POWER on the bottom-left of the front of the plasma display.

The POWER ON indicator lights blue.

• To switch the system back into standby, press on the remote control unit or STANDBY/ON on the plasma display’s control panel on the right-hand side.

The STANDBY indicator lights red.

PDP-507XG

PDP-427XG

POWER ON indicator

STANDBY indicator

POWER ON STANDBY

POWER button

• You can then turn on the system again by pressing or 0 to 9 on the remote control or STANDBY/ON on the plasma display. If you press 0 on the remote control unit, images come from the INPUT 1 source. If you press 1 to 9, TV images display.

•You can also press POWER on the plasma display to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit or STANDBY/ON on the plasma display.

Note

•If you are not going to use the plasma display for a long period of time, be sure to remove the power cord from the power outlet.

plasma display status indicators

The table below shows the operational status of the plasma display. You can check the current status of the system with the indicators on the plasma display.

06

English

Indicator status System status

POWER ON STANDBY

POWER ON indicator

STANDBY indicator

POWER ON STANDBY

POWER button

POWER ON STANDBY

The power cord of the plasma display has been disconnected. Or, the power cord of the plasma display has been connected but the POWER button of the plasma display is off.

Power to the system is on.

The system is in the standby mode.

For other than the above, see Troubleshooting on page 48.

19

En