Pioneer PDP-507XG manual Additional information, Signal assignments for 15-pin D-sub connector

Additional information 12

Problem Possible solution

•POWER ON indicator or STANDBY indicator • Internal protective circuits may have been activated. First turn the main power off by pressing POWER on the

is quickly flashing.	plasma display, and then turn the power on again in after one minute or more.
	• If the problem is not solved with this, contact a Pioneer Service Center or Pioneer Authorized Independent Service
	company. These are listed on your warranty card for each country or region.

If the following error codes appear on the screen, check the corresponding items in the table.

Code	Message	Check
SD04 and SD11	Powering off. Internal temperature too high.	Check if the ambient temperature of the plasma display is high.
	Check temperature around PDP.
SD05	PDP-507XG
	Internal protection circuit turns power off.	Check the speaker cable connections between the plasma display and
	Is there a short in the speaker cable?	the speakers.
	PDP-427XG
	Internal protection circuit turns power off.	Contact a Pioneer Service Center or Pioneer Authorized Independent
		Service company. These are listed on your warranty card for each
		country or region.

English

Signal assignments for 15-pin D-sub connector

Pin No.	Signal assignment	Pin No.	Signal assignment
1	R	9	+5 V
2	G	10	GND (ground)
3	B	11	Not connected
4	Not connected	12	SDA
5	Not connected	13	HD
6	GND (ground)	14	VD
7	GND (ground)	15	SCL
8	GND (ground)

Standard channel allocation selections for countries and regions

Region	Standard channel allocation	Region	Standard channel allocation
Taiwan	Cable (US Type)	Lebanon	Normal
Hong Kong	Normal	United Arab Emirates	Normal
Philippines	Cable (US Type)	Mexico	Cable (US Type)
Thailand	Normal	Chile	Cable (US Type)
Malaysia	Normal	Brazil	Cable (US Type)
Singapore	Normal	Australia	Normal
Indonesia	Normal	New Zealand	Normal
Saudi Arabia	Normal	Egypt	Normal
Israel	Normal	South Africa	Normal

49

En