Pioneer PDP-5080HD operating instructions Screw M5 x 10 mm, Speaker Speaker mounting fitting

➀ Tighten the screw in the upper screw hole first.

➁ Then, tighten the screw in the screw hole right under the upper hole.

Preparation 05

PDP-5080HD with the speaker installed (with the Pioneer table top stand)

Speaker mounting screw (M5 x 10 mm)

Speaker mounting		Speaker mounting
screw (M5 x 10 mm)
		screw (M5 x 10 mm)
	Speaker
Speaker mounting fitting	Speaker mounting fitting	Speaker mounting fitting
(side)	(center)	(side)
Speaker cable	Bead band

English

Note

•Before installing the speaker, make sure that the Pioneer table top stand is attached to the plasma display.

1Attach the speaker mounting fittings to the rear of the plasma display.

•Attach the fittings for right and left sides to the bottom right and left on the rear panel of the plasma display using the supplied screws.

•Attach the fitting for center to the lower center on the rear panel of the plasma display using the two supplied screws.

Speaker mounting screw (M5 x 10 mm)

➁Then, tighten the screw in the oval-shaped screw hole.

Speaker mounting screw (M5 x 10 mm)

➀Tighten the screw in the round- shaped hole first.

Speaker mounting fitting for side

(It shows the attachment of the fitting on the left side. It is attached on the right side by the same procedure.)

Speaker mounting fitting for center

17

En