Pioneer PDP-5080HD Routing cables, Connecting the power cord, Plasma display rear view

Speaker cable

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the plasma display and snap [2] into the back of [1] to lock the clamp. Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.

Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed.

2 1

Note

• Use the supplied bead bands and speed clamps as necessary.

• When tidying up your speaker cables, make sure to bundle them so that they are not subjected to any pressure.

Preparation

Routing cables

When the speaker is installed under the plasma display panel (for PDP-5080HD only)

Rear view

4 5

Bead band

Attaching speed clamps to the main unit

Attach the speed clamps using the three holes (42 inches: two holes) marked with below, depending on your routing system.

for PDP-5080HD

for PDP-4280HD

05

English

Connecting the power cord

Connect the power cord after all component connections have been completed.

Plasma display (rear view)

Caution

•Use only the supplied power cord.

•Be sure to use the specified power supply voltage; neglecting this can result in fire or electric shock.

•For the plasma display, a three-core power cord with a ground terminal is used for efficient protection. Always connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded.

AC IN terminal is located on the upper edge of the compartment.

Noise filter

Power cord Partially eliminates noise

caused by the power source.

Note

•Always turn off the power of the plasma display when connecting or disconnecting power cords.

•Disconnect the power cord from the power outlet when the plasma display is not going to be used for a long period of time.

25

En