Pioneer PDP-5080HD Sleep Timer, No Operation off AV source only, Power Management PC source only

Adjustments and Settings 11

No Operation off (AV source only)

The system will be automatically placed into the standby mode when no operation is performed for three hours.

1Press HOME MENU.

2Select “Power Control” (/ then ENTER).

3Select “No Operation off” (/ then ENTER).

4Select “Enable” (/ then ENTER).

Item	Description
Disable	Does not place the system into the standby mode
(default)
Enable	Places the system into the standby mode if no
	operation is performed for three hours

5Press HOME MENU to exit the menu.

Note

•Five minutes before the system is placed into the standby mode, a message appears every minute.

Power Management (PC source only)

The system will be automatically placed into the standby mode when no signal is received from the personal computer.

1Press HOME MENU.

2Select “Power Control” (/ then ENTER).

3Select “Power Management” (/ then ENTER).

4Select “Mode 1” or “Mode 2” (/ then ENTER).

Item	Description
Off	No power management
(default)
Mode 1	• Places the system into the standby mode when no
	signal is received from the personal computer for
	eight minutes.
	• Even when you start using the computer and a
	signal is received again, the system stays off.
	• The system is switched on again by pressing
	STANDBY/ON on the plasma display or TV	on
	the remote control unit.
Mode 2	• Places the system into the standby mode when no
	signal is received for eight seconds.
	• When you start using the computer and a signal is
	received again, the system is switched on.
	• The system is switched on again by pressing
	STANDBY/ON on the plasma display or TV	on
	the remote control unit.

Sleep Timer

When the selected time elapses, the Sleep Timer automatically places the system into the standby mode.

1Press HOME MENU.

2Select “Sleep Timer” (/ then ENTER).

3Select the desired time (/ then ENTER).

Select “Off” (cancel), “30 min”, “60 min”, “90 min” or “120 min”.

4Press HOME MENU to exit the menu.

Note

•Five minutes before the selected time elapses, the remaining time appears every minute.

•To check the remaining time, perform steps 1 and 2. After checking the time, press HOME MENU to restore the previous display.

•The SLEEP indicator on the front of the plasma display lights orange when the sleep timer is set.

English

5Press HOME MENU to exit the menu.

Note

•This function is not selectable when the PC is connected to the HDMI terminal.

59

En