57
En
Adjustments and Settings 11
English
7Press HOME MENU to exit the menu.
Comparing picture adjustments on the screen
During picture adjustments, you can quickly refer to the image
previously set in the same parameter, allowing you to easily
compare and select the preferred image quality.
1Press HOME MENU.
2Select “Picture” ( / then ENTER).
3Select an item to be adjusted ( / then ENTER).
4While performing adjustment, press BLUE on the
remote control unit.
“Before” displays and the image adjusted last time appears for
comparison.
5Press the button again to return to the newly adjusted
image.
Each press of the button toggles between “Before” and “After”.
6Repeat steps 1 and 5 for other parameters.
7Press HOME MENU to exit the menu.
Caution
• If you exit the menu by pressing HOME MENU or no operation
is performed for 60 seconds, all the parameter settings
displayed last are stored in memory.
• If you want to exit the menu without performing the
adjustments (or leaving the settings disabled) on the “After”
screen, switch to “Before” and then exit.
Note
• You cannot adjust any item while on the “Before” screen. A
warning message appears.
• When you switch to another parameter, make sure to change
the display from “Before” to “After” first, otherwise you cannot
select “Before”. A warning message appears if you don’t.
• If you exit the selection from the “Before” screen, the previous
entry is stored in the memory and the button no longer works.
• If you exit the selection from the “After” screen, the new entry
is stored in the memory and the button no longer works.
• If you move and change the “AV Selection” parameter, the new
entry in the current parameter is stored in the memory and the
button continues to work.
• You cannot compare images between different parameters on
the “AV Selection” menu (“STANDARD” and “MOVIE”, for
example).
• When you select this function, “OPTIMUM” on the “AV
Selection” menu and “Room Light Sensor” on the “Option”
menu are set to off and image quality returns to default
settings.
• This function is not selectable:
- when you select “AV Selection”,
- when you select “Yes” or “No” on the confirmation screen for
“Reset” from the “Picture” menu or
- when you select a menu from the PC source
Sound adjustments
You can adjust the sound quality to your preference with the
following settings.
Adjust the sound to your preference for the chosen AV Selection
option. See page 54.
1Press HOME MENU.
2Select “Sound” ( / then ENTER).
3Select an item to be adjusted ( / ).
4Select the desired level ( / ).
5Press HOME MENU to exit the menu.
Note
• You cannot adjust the sound for listening with headphones.
• If you perform sound adjustments with headphones
connected, the new settings will become effective as soon as
you disconnect the headphones.
• To restore the factory defaults for all the items, press / to
select “Reset” in step 3, and then press ENTER. A confirmation
screen appears. Press / to select “Yes”, and then press
ENTER.
Field NR
Removes glimmer for more natural images
Selections Off Deactivates Field NR
High Enhanced Field NR
Mid Standard Field NR
Low Moderate Field NR
Before
Item button button
Treble For weaker treble For stronger treble
Bass For weaker bass For stronger bass
Balance Shifts the audio balance to
the left
Shifts the audio balance to
the right
Bass
Balance
Reset
Sound Effect
0
0
Sound
STANDARD
Treble 2
PDP5080HD.book Page 57 Monday, April 9, 2007 7:49 PM