Pioneer PDP-5080HD Tighten from back using the supplied screws three locations

05Preparation

2Fit the speaker to the mounting fittings in the correct direction.

• Be sure not to mount the speaker upside down.

Protective wrapping

Front side of the speaker

The side with the padding strip is facing upwards.

For illustrative purposes, the table top stand is not presented here.

Insert the groove on the back of the speaker into the speaker mounting fitting.

Caution

•To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting fittings while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped between the speaker and stand.

•When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings angle.

3Tighten from back using the supplied screws (three locations).

Tighten the three screws in order 1, 2, 3 as shown in the diagram.

3

Speaker mounting screw	1
(M5 x 10 mm)
Speaker mounting screw		When using the
(M5 x 10 mm)
		table top stand, do	2
		not use these holes.

Speaker mounting screw (M5 x 10 mm)

Caution

•If you want to move the plasma display, make sure that you remove the speaker first. In addition, do not move the plasma display holding on to the mounting fittings. This can result in injury or damage to the unit.

The screw hole at the bottom of the speaker mounting fitting is used when the plasma display is installed on the wall. It is not used when installed with the stand.

Note

•If after attaching the speaker its position needs to be adjusted horizontally or vertically, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position.

18

En