05Preparation

Attaching/detaching the Pioneer stand

The plasma display comes with the Pioneer table top stand attached. You can also install the display on a rack by detaching the stand. The method for attaching/detaching the stand varies depending on the product.

Caution

This product can be used only with the attached stand. Using other stands can result in instability, possibly causing injury.

The weight of a 50 inch plasma display is about 34.8 kg (76.7 lbs.) and a 42 inch about 29.9 kg (65.9 lbs.), it has no depth, and is unstable. Therefore, at least two people must assemble and install it.

Detaching the stand

When removing the stand before you install the speaker, begin with step 2 (for PDP-5080HD).

Begin with step 2 for PDP-4280HD.

Besides the speaker, steps for detaching the stand are the same for PDP-5080HD and PDP-4280HD. Illustrations shown are for PDP-5080HD.

1Detach the supplied speaker if it has already been installed.

To detach the speaker, remove the cable wiring for the speaker at the rear and screws at the rear of the speaker and pull it out (see step 3 on page 18).

Use the protective sheet in which the speaker was wrapped between the speaker and stand.

Make sure to remove the speaker mounting fittings.

2With the plasma display lying flat, loosen and remove the two installation bolts (1) and (2) using a screwdriver.

Installation bolts (1): M8 x 23 mm (black) for PDP-4280HD M8 x 23 mm (black) for PDP-5080HD

Installation bolts (2): M8 x 60 mm (black) for PDP-4280HD M8 x 40 mm (black) for PDP-5080HD

Installation bolts (1) (Step 1)

Installation bolts (2) (Step 2)

Table top stand

Sheet

3Remove the stand from the plasma display.

Note

Make sure to keep the installation bolts (1) and (2) that have been removed as they are re-used when attaching the stand to the plasma display.

Place a sheet or protective cover to protect the display from scratches or damage.

Work only with the plasma display lying flat on a table or similar surface.

When lying the plasma display down, be careful not to scratch or damage it.

22

En

Page 22
Image 22
Pioneer PDP-5080HD Attaching/detaching the Pioneer stand, Detaching the stand, Remove the stand from the plasma display