Pioneer VSX-515-S/-K Additional information, Set the Signal Select to AUTO, Digital or Analog

Additional information 11

Problem	Remedy
Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 20).
selected automatically.
No sound from surround or	• Connect the speakers properly. Refer to page 21 (VSX-415) or
center speakers.	page 22 (VSX-515).
	• Refer to Speaker setting on page 41 (VSX-415) or page 48 (VSX-515)
	to check the speaker settings.
	• VSX-415 only – Refer to Setting separate channel levels for listening
	modes on page 43 to check the speaker levels.
	• VSX-515 only – Refer to Channel level on page 50 to check the
	speaker levels.
No sound from surround	• Refer to Speaker setting on page 48 to check the surround back
back speakers (VSX-515 model	speaker settings.
only).	• Refer to Channel level on page 50 to check the speaker levels.
	• Refer to Using the surround back channel (Extended mode) on
	page 36 to make sure the Extended mode and the sound mode are
	set for surround back sound.
No sound from subwoofer.	• Make sure the subwoofer is switched on.
	• If the subwoofer has a volume knob, make sure it’s turned up.
	• The Dolby Digital or DTS source you are listening to may not have
	an LFE channel.
	VSX-415 model only:
	• Switch the Subwoofer setting on page 41 to YES or PLUS.
	• Switch the LFE attenuator setting on page 41 to 0 dB or 10 dB.
	VSX-515 model only:
	• Switch the subwoofer setting in Speaker setting on page 48 to YES
	or PLUS.
	• Switch the LFE Attenuator Setup on page 52 to LFEAT 0 or LFEAT
	10.
Noise during playback of a	• Move the cassette deck further from your receiver, until the noise
cassette deck.	disappears.
Sound is produced from	• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG
other components, but not	according to the type of connections made. (refer to page 34).
from LD or DVD player.	• Set the digital input settings correctly. Refer to page 43 (VSX-415)
	or page 51 (VSX-515).
	• Make digital connections (refer to page 16) and set the SIGNAL
	SELECT to DIGITAL (refer to page 34).
	• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise	• Set the digital volume level of the player to full, or to the neutral
is output when software with	position.
DTS is played back.

English Deutsch Français Italiano Nederlands Español

59

En