Pioneer VSX-515-S/-K Connecting up Connecting the speakers VSX-415, Front speakers Center speaker

Connecting up

Connecting the speakers (VSX-415)

A complete setup of six speakers (including the subwoofer) is shown below, but everyone’s home setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best. If you’re not using a subwoofer, change the front speaker setting (see Speaker setting on page 41) to large.

Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative (+/–) terminals on the receiver match those on the speakers. You can use speakers with a nominal impedance between 6–16Ω(please see Switching the speaker impedance on page 61 if you plan to use speakers with an impedance of less than 8Ω).

Be sure to complete all connections before connecting this unit to the AC power source.

Front speakers		Center speaker		Surround speakers
L	R		C	LS	RS

04

English Deutsch Français Italiano

R	AUDIO	L
		FM UNBAL
		75 Ω
IN		CD
OUT		DVR/
		VCR
DIGITAL IN
IN		VIDEO
OPT

AM

LOOP ANTENNA

VSX-415

CENTER- SUB WOOFER

RL

SURROUND

DVD 5.1CH INPUT

Nederlands

1	IN
	TV /
(TV /	SAT
SAT)	IN
ASSIGNABLE COAX	IN
	DVD

2/LD

FRONTIN

(CD)		D V D
COAX	REC	5.1CH
		INPUT
1	CD-R	IN
(DVD OUT	/ TAPE
/LD)	/ MD
IN	PLAY

OUT	S	R FRONT L	CENTER	R SURROUND L
	P
MONITOR	E
OUT	A
SUB	K
WOOFER	E
PREOUT
	R
	S

Español

Powered subwoofer	1	2	3
SW
INPUT		10mm

1Twist exposed wire strands together.

2Loosen terminal and insert exposed wire.

3Tighten terminal.

21

En