Pioneer VSX-415-S/-K Distance setting on page 42 to compensate for a delay, Mcacc Setup

11Additional information

Problem	Remedy
When a search is performed	• This is not a malfunction, but be sure to turn the volume down to
by a DTS compatible CD	prevent the output of loud noise from your speakers.
player during playback, noise
is output.
Everything seems to be set up	• Check that the positive/negative speaker terminals on the receiver
correctly, but the playback	are matched with the corresponding terminals on the speakers.
sound is odd.	Refer to page 21 (VSX-415) or page 22 (VSX-515).
There seems to be a time lag	• VSX-415 model only – You may need to decrease the Subwoofer
between the speakers and the	distance setting on page 42 to compensate for a delay in the
output of the subwoofer.	subwoofer output.
	• VSX-515 model only – See Automatically setting up for surround
	sound (MCACC) on page 13 to set up your system again using
	MCACC (this will automatically compensate for a delay in the
	subwoofer output).
After using the Auto MCACC	• Low-frequency noise could have been caused by an air conditioner
Setup, the speaker size	or motor. Switch off all appliances in the room and rerun the Auto
setting (LARGE or SMALL) is	MCACC Setup.
incorrect (VSX-515 model
only).
Can’t operate the remote	• Replace the batteries (refer to page 6).
control.	• Operate within 7 m, 30° of the remote sensor on the front panel
	(refer to page 6).
	• Remove the obstacle or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct light.

The display is dark or off.

•Press FL DIMMER on the remote control repeatedly to return to the default.

60

En