Pioneer VSX-515-S/-K, VSX-415-S/-K Quick surround sound setup Chapter, English

Quick surround sound setup

Chapter 3:

Quick surround sound setup

VSX-515 model only

03

English

Automatically setting up for surround sound (MCACC)

The Auto Multi-Channel Acoustic Calibration (MCACC) setup measures the acoustic characteristics of your listening area, taking into account ambient noise, speaker size and distance, and tests for both channel delay and channel level. After you have set up the microphone provided with your system, the receiver uses the information from a series of test tones to optimize the speaker settings and equalization for your particular room.

Important

•The Auto MCACC Setup will overwrite any existing speaker settings you’ve made.

•Make sure the headphones are unplugged.

Caution

•The test tones used in the Auto MCACC Setup are output at high volume.

			ADVANCED	MIDNIGHT/
			STANDARD SURROUND STEREO	LOUDNESS
RECEIVER SLEEP FL DIMMER INPUT ATT			TOP MENU	MENU
			SYSTEM	RETURN
INPUT SELECTOR			SETUP
			ENTER
DVD/LD DVD 5.1CH	TV/SAT	DVR/VCR		RECEIVER
			DVD
CD-R/	FM	AM
CD TAPE/MD			RECEIVER CONTROL

1Connect the microphone to the MCACC SETUP MIC jack on the front panel.

Make sure there are no obstacles between the speakers and the microphone.

FMAM

MASTER

VOLUME

MCACC

SETUP MIC

DOWN UP

If you have a tripod, use it to place the microphone so that it’s about ear level at your normal listening position. Otherwise, place the microphone at ear level using a table or a chair.

2 If the receiver is off, press RECEIVER to turn the power on.

3If you have a subwoofer, turn it on.

4Press RECEIVER on the remote control, then press the SYSTEM SETUP button.

•Press SYSTEM SETUP again at any time to exit the System Setup menu.1

5Select ‘A. MCACC’ from the System Setup menu then press ENTER.

Try to be as quiet as possible after pressing ENTER. The system outputs a series of test tones to establish the ambient noise level.

If the noise level is too high, NOISY! blinks in the display for five seconds. To exit and check the noise levels again, press SYSTEM SETUP (see the notes about ambient noise below) or press ENTER when you’re prompted to RETRY?

•Do not adjust the volume during the test tones. This may result in incorrect speaker settings.

The system now checks the microphone and your speaker setup.

Deutsch Français Italiano Nederlands Español

Note

1The receiver will automatically exit the current menu after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the receiver automatically exits and no settings will be made.

13

En