Additional information
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the TONE button,
press and hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press the TONE button.
OK? shows in the display.
4Press TONE once more to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
1Switch the receiver into standby.
2While holding down the TONE button,
press and hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press the ENTER button.
OK? shows in the display.
4Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
Switching the speaker impedance
We recommend using speakers of 8Ω with this system, but it is possible to switch the imped- ance setting if you plan to use speakers with a 6Ω impedance rating.
•With the receiver in standby, press STANDBY/ON while holding down the SPEAKER IMPEDANCE button.
Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8Ω or more.
11
English Deutsch Français Italiano Nederlands Español
61
En
