Pioneer VSX-D812, VSX-D912 Operating other Pioneer, Components, Power cord caution, Receiver

Connecting up

•To hear sound only from the pre-outs, disconnect any speakers that are connected directly to the receiver.

•If you’re not using a subwoofer, change the front speaker setting (see Speaker setting on page 44) to large.

•VSX-D712 only – If you connect to a surround back speaker, make sure the Surround back speaker setting on page 45 is switched on and set to the proper speaker size.

•These speaker terminals are hazardous when live. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord.

Power cord caution

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement.

04

Operating other Pioneer			English
components
By connecting a control cord (optional), you
can point the remote controls of other Pioneer
components at the receiver’s remote sensor.
The remote control signals are received by the
remote sensor of this unit, and sent to the
other devices via the CONTROL OUT terminal			Italiano
of the receiver.
		CONTROL
OUT	IN	IN
	CONTROL	OUT
	Receiver		Français
	Remote	with CONTROL terminals
		Other Pioneer products
	control	Connect to CONTROL
	unit
		terminal of other	Deutsch
		compatible Pioneer products
			Nederlands
			Español

27

En