Pioneer VSX-D912, VSX-D812 operating instructions 02 5 minute guide Using the Quick Setup, 1ch, 0ch

025 minute guide

Using the Quick Setup

You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup, room size and listening position.

Note that with the VSX-D912 you don’t have to make these settings if you use the automatic MCACC setup instead (in this case, go straight to the Quick surround sound setup on page 14).

If you want to make more specific settings, refer to Choosing your receiver setup on page 43.

Use the front panel controls for the steps below.

MULTI JOG

ENTER

MASTER VOLUME

ADVANCED	STEREO/	SIGNAL	MIDNIGHT/		MONITOR	TONE	QUICK	SETUP
SURROUND	DIRECT	SELECT	LOUDNESS	SPEAKERS
								DOWN	UP
ENING MODE						MULTI JOG
					VIDEO INPUT
L DIMMER
			DIGITAL IN	S-VIDEO	VIDEO	L	AUDIO	R

3Use the MULTI JOG dial to choose your speaker setup.

When a subwoofer was detected in step 2, you can cycle between the following choices:

2.1ch	3.1ch
7.1ch*	4.1ch
6.1ch	5.1ch

*VSX-D812/D912 only

If a subwoofer wasn’t detected in step 2, you can cycle between the following choices:

2.0ch	3.0ch
7.0ch*	4.0ch
6.0ch	5.0ch

*VSX-D812/D912 only

•Check the table below to find the speaker setup that corresponds with your system.

1If the receiver is off, press STANDBY/ON to turn the power on.

The STANDBY indicator goes out.

2 Press QUICK SETUP.

SW DET flashes in the display while the receiver checks your setup for a subwoofer. SW YES or SW NO confirms the subwoofer check, then the display prompts you to select your speaker setup.

* VSX-D812/D912 only

12

En