Pioneer VSX-D812 Additional information, Set the Signal Select to AUTO, Digital or Analog

Additional information 11

Problem	Remedy
Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 21).
selected automatically.
No sound from surround or	• Refer to Speaker setting on page 44 to check the speaker settings.
center speakers.	• Refer to Manually calibrating your listening area (MCACC) on
	page 49 (with the VSX-D912, you can do this using the Quick
	surround sound setup on page 14) to check the speaker levels.
	• Connect the speakers properly (refer to page 22).
No sound from surround	• Refer to Surround back speaker setting on page 45 to check the
back speakers.	surround back speaker settings.
	• Refer to Manually calibrating your listening area (MCACC) on
	page 49 (with the VSX-D912, you can do this using the Quick
	surround sound setup on page 14) to check the speaker levels.
	• Refer to Using the Surround Back Channel (SB CH) on page 39 to
	make sure the SB CH MODE and the sound mode are set for
	surround back sound.
No sound from subwoofer.	• Make sure the subwoofer is switched on.
	• If the subwoofer has a volume knob, make sure it’s turned up.
	• Switch the Subwoofer setting on page 45 to YES or PLUS.
	• Switch the LFE attenuator setting on page 46 to 0 dB or 10 dB.
	• The Dolby Digital or DTS source you are listening to does not have
	an LFE channel.
Noise during playback of a	• Move the cassette deck further from your receiver, until the noise
cassette deck.	disappears.
Sound is produced from	• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG
other components, but not	according to the type of connections made. (refer to page 36).
from LD or DVD player.	• Set the digital input settings correctly (refer to page 48).
	• Make digital connections (refer to page 17) and set the SIGNAL
	SELECT to DIGITAL (refer to page 36).
	• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise	• Set the digital volume level of the player to full, or to the neutral
is output when software with	position.
DTS is played back.
When a search is performed	• This is not a malfunction, but be sure to turn the volume down to
by a DTS compatible CD	prevent the output of loud noise from your speakers.
player during playback, noise
is output.

English Italiano Français Deutsch Nederlands Español

71

En