Setting up
Chapter 7:
Setting up
Choosing your receiver setup
To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly important when using DTS and Dolby surround. You only need to make these settings once (unless you change the placement of your current speaker system or add new speakers, etc.). Refer to the following pages for details on each of the settings.
RECEIVER
RECEIVER
| ENTER |
1 | Press RECEIVER to turn the power |
on. |
|
The STANDBY indicator goes out. | |
2 | Press RECEIVER. |
3 | Use or to choose the option you |
want to adjust.
It will be easiest to adjust each of the settings in turn, following the order below (and on the following pages). The current setting is shown for each option as you cycle through the display.
Speaker setting (page 44)
Specify the number and type of speakers you have connected.
Surround back speaker setting (page 45)
Specify your surround back speaker/ surround back subwoofer setup.
Subwoofer setting (page 45) Specify how the subwoofer is used.
Crossover frequency setting (page 45) Determine which frequencies will be sent to the subwoofer (or large speakers).
LFE attenuator setting (page 46) Choose the attenuator level for the LFE channel.
Front left speaker distance setting (page 46)
Specify the distance from your listening position to your front left speaker.
Center speaker distance setting
(page 46)
Specify the distance from your listening position to your center speaker.
Front right speaker distance setting (page 47)
Specify the distance from your listening position to your front right speaker.
Surround right speaker distance setting (page 47)
Specify the distance from your listening position to your surround right speaker.
07
English Italiano Français Deutsch Nederlands Español
43
En
