Pioneer VSX-D812, VSX-D912 operating instructions Listening to multi-channel playback

Playing sources

•Press SIGNAL SELECT (front panel) to select the input signal corresponding to the source component.

Each press cycles through the options as follows:

	AUTO
		DVD 5.1 ch/
DIGITAL
		DVD 7.1 ch
	ANALOG

The AUTO setting automatically switches to DIGITAL if a digital source is detected, other- wise the signal select will be ANALOG.

DVD 5.1ch (VSX-D712) and DVD 7.1ch (VSX- D812/D912) will only appear when DVD/LD is selected.

When set to DIGITAL or AUTO, 2 DIGITAL lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input.

•This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz) and DTS digital signal formats (however, only the VSX-D812 and VSX-D912 can decode DTS 96kHz/24 bit signal formats). With other digital signal formats, set to ANALOG.

•You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make the proper digital connections (page 17) and set the signal input to DIGITAL.

•Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.

Listening to multi-channel playback

RECEIVER

INPUT SELECT

MULTI CONTROL

DVD/LD	TV/SAT	VCR/DVR	TV CONT
C D	CD-R/TAPE	TUNER
STANDARD

1Switch on the playback component.

2Turn on the power of the receiver.

3Select the source you want to play- back.

Use the MULTI CONTROL buttons (or INPUT SELECT).

4Press STANDARD.

If the source is Dolby Digital, DTS, or Dolby Surround encoded, the proper decoding format will automatically be selected and shows in the display.

If you are listening to a two channel source, each press changes the display as follows:

MOVIE

(2 Pro Logic II)

MUSIC		MUSIC
(Neo:6)		(2 Pro Logic II)
	CINEMA	PROLOGIC
	(Neo:6)

Refer to page 35 for more details about each mode.

06

English Italiano Français Deutsch Nederlands Español

37

En