Introduction
Safety and Compliance
Mains Connection
In most countries your system is supplied with a moulded mains lead and plug. In other countries, or if the supplied lead is not used, the following information applies:
1.An approved mains lead for the country concerned must be used.
2.As the colours of the wires in the mains lead of this equipment may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
-The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter “E” or by the earth symbol
or coloured green or green and yellow.
-The wire which is coloured blue must be connected to the terminal which is marked with the letter “N” or coloured black.
-The wire which is coloured brown must be connected to the terminal which is marked with the letter “L” or coloured red.
3. The wires in the supplied mains lead are coloured in accordance with the
following code: |
|
|
Green and Yellow | - | Earth |
Blue | - | Neutral |
Brown | - | Live |
WARNING:
THE DIGITAL MAILING SYSTEM MUST BE EARTHED
The socket outlet should be near to the equipment
and should be easily accessible.
Do not route the power cord over sharp edges or trap it
between pieces of furniture.
Make sure there is no strain on the power cord.
In case of an ink spill, leaking ink, or excessive ink accumulation, immediately disconnect power cord from wall plug
and call your Pitney Bowes office for assistance.