PowerTec DFS-1 manual Analog Output #1 Mode Select, Analog Output #1 LOW Engineering Units EGU

25.ANALOG OUTPUT #1 MODE SELECT

USE PARAMETER #25 TO SELECT THE SOURCE OF A SIGNAL AT ANALOG OUTPUT #1.

RANGE OF VALUES: 0000 0000h to 0000 0003h

0 to 4 (decimal)
Default Value: 0000 0001h	1 (decimal)

Analog Output #1 may be programmed for several modes of operation. The mode affects where the signal at Analog Output #1 comes from. The following modes are provided for:

0000 0000h	Disabled.
0000 0001h	Actual Speed - Represents the speed
	of the motor from 0 to parameter #14.
0000 0002h	Load Output - Represents the load on
	the motor from 0 to 1500.
0000 0003h	Analog Output voltage set by
	communications from parameters #26
	and #27.
0000 0004h	Commanded Speed

If an undefined mode (...05h through ...1Fh) is selected, Analog Input #1 will be inoperative.

26.ANALOG OUTPUT #1 LOW ENGINEERING UNITS (EGU)

USE PARAMETER #26 TO SELECT THE THRESHOLD OF ANALOG OUTPUT #1 EFFECT. RANGE OF VALUES: FFFE 7961h to 0001 869Fh

-99,999 to +99,998 (dec.)

Default Value: 0000 0000h 0 (decimal)

Parameter #26 sets the point, in EGU’s, at which the Analog Output #1 will be -10VDC.

27.ANALOG OUTPUT #1 HIGH ENGINEERING UNITS (EGU)

USE PARAMETER #27 TO SELECT THE MAXI- MUM ANALOG OUTPUT #1 EFFECT.

RANGE OF VALUES: FFFE 7961h to 0001 869Fh -99,999 to +99,998 (dec.)

Default Value: 0000 06D6h 1750 (decimal)

If parameter #27 is greater on the absolute scale than #26, voltage at Analog Output #1 will be scaled proportionally from low EGU’s (parameter #26) to +10VDC at the high engineering units (parameter #27).

If #27 is less than #26, then output sense is inverted, i.e., the higher voltage (from -10VDC to +10VDC) will be at the low EGU setting (#26) and the lower voltage will be at the high EGU setting (parameter #27).

28.ANALOG OUTPUT #2 MODE SELECT

USE PARAMETER #28 TO SELECT THE SOURCE OF A SIGNAL AT ANALOG OUTPUT #2.

RANGE OF VALUES: 0000 0000h to 0000 0003h

0 to 4 (decimal)
Default Value: 0000 0000h	0 (decimal)

Analog Output #2 is a general purpose analog output which may be programmed for one of several modes of operation. The mode defines the origin of the signal at Analog Output #2. The following modes are provided for:

0000 0000h	Disabled.
0000 0001h	Actual Speed - Represents the speed
	of the motor from 0 to parameter #14.
0000 0002h	Load Output - Represents the load on
	the motor from 0 to 1500.
0000 0003h	Analog Output voltage set by commu-
	nications from parameters #29 and
	#30.
0000 0004h	Commanded Speed

If an undefined mode ...05h through ...1Fh is selected, Analog Input #2 will be inoperative.

Revised 7/95	DFS-1 Manual	Page 27
POWERTEC Ind. Corp.©