Psion Teklogix 7525 Pcmcia Module And Mechanical Stopper, Installing The PC Card Expansion Module

Chapter 8: Expansion Modules

Installing The PC Card Expansion Module

To insert a PCMCIA PC card in your WORKABOUT, you will need to install a PCMCIA module equipped with a 100-pin connector. This module snaps onto the expansion connector on your WORKABOUT PRO.

Important: Backup any data in RAM first, since it will be erased when the unit is turned off.

Mechanical Stopper

PCMCIA Expansion Module

Figure 8.4 PCMCIA Module And Mechanical Stopper

•Remove the battery. If your unit is using AC power, disconnect it.

•Remove the end-cap and back plate.

•Slide the SW1401 switch to the left to shut off internal battery power.

•Remove the two screws at the top of the metal frame.

•Align the PCMCIA Card connector with the expansion connector on the WORKABOUT PRO. Apply slight pressure to snap the module into place on the hand-held.

•Use four of the screws provided to secure the PCMCIA Card into place (additional screws have been provided for convenience). Tighten the screws to a torque of 2 lbs-in (2 kgf-cm), or until finger tight.

Important: Once the PCMCIA module is installed in the unit, you do not need to remove the back plate to insert a PCMCIA PC card. Just remove the end-cap and slide the card into the unit.

264Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual