Psion Teklogix 7525 user manual Installing An SE 923HP Scanner, Enabling The SE 1223HP Scanner

Chapter 8: Expansion Modules

Enabling The SE 1223HP Scanner

•Fit the scanner module over the back of the WORKABOUT PRO–it replaces the back plate of the unit.

•Fasten the module in place with the screws provided. Tighten the screws to a torque of 3 lbs-in (3kgf-cm).

•Slide the SW1401 power switch to the right to turn power back on, and replace the end-cap, backplate and battery. Tighten the end-cap screws to a torque of 3 lbs-in (3kgf-cm).

Figure 8.10 Scanner Module Installed In WORKABOUT PRO

8.1.6.1Enabling The SE 1223HP Scanner

•Simultaneously, press and hold down the <BLUE> <ENTER> and left <SCAN> keys for a minimum of 6 seconds. A Command> prompt is displayed on the WORKABOUT PRO screen.

•Type s to display the Scanner> prompt. A list of supported scanners is displayed.

•Type 2 and press <ENTER> to activate scanner type SE 1223HP.

•At the Command> prompt, type 1 (one) to reboot the unit to Windows Mobile 2003 SE.

8.1.7 Installing An SE 923HP Scanner

Warning:	Anti-static devices MUST BE USED during the installation of
	this scanner module. If unavailable, discharge static from your
	body by touching a grounded metallic object before opening any
	covers on the unit.

Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual 269