Psion Teklogix 7525 user manual Inserting The SIM Into The GSM/GPRS Module

Chapter 8: Expansion Modules

Installing A GSM/GPRS Module

•Remove the stylus from the end-cap, and then remove the end-cap at the top of the WORKABOUT PRO.

•Slide the SW1401 switch to the left to shut off internal battery power.

Important: In order for the WORKABOUT PRO to access the GSM network, ensure that you slide the SIM (Subscriber Identity Module) card into the GSM/GPRS module before installing that unit in the

WORKABOUT PRO.

With the power shut down, you can install the GSM/GPRS module and the antenna.

•Slide the SIM card into the GSM/GPRS module as shown in Figure 8.6, with the card oriented printed side up and its notch on the right side.

•Align the GSM/GPRS connector with the expansion connector on the WORKABOUT PRO. Apply slight pressure to snap the module into place on the hand-held.

•Settle the SIM Card stopper plate into place with its metal tab inserted into the SIM Card stopper plate slot on the GSM/GPRS module (for tab and slot locations see Figure 8.6). Ensure that the scanner flex cable lies on top of the plate.

•Use the four screws provided to secure the module and SIM Card stopper plate in place. Tighten the screws to a torque of 2 lbs-in (2 kgf-cm) or until finger tight

SIM Card

Bracket

GSM/GPRS

Radio

SIM Card

Stopper Plate

Slot

GSM/GPRS Module with SIM Card installed

SIM Card Stopper Plate

SIM Card

Tab

Figure 8.6 Inserting The SIM Into The GSM/GPRS Module

266Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual