Psion Teklogix 7525 user manual Installing An SE 1223HP Scanner

Chapter 8: Expansion Modules

Installing An SE 1223HP Scanner

8.1.6 Installing An SE 1223HP Scanner

Warning:	Anti-static devices MUST BE USED during the installation of
	this scanner module. If unavailable, discharge static from your
	body by touching a grounded metallic object before opening any
	covers on the unit.

The SE 1223HP scanner (model # WA9000) is the internal scanner module available with the WORKABOUT PRO. To install it:

•Remove the battery. If your unit is using AC power, disconnect it.

•Remove the stylus and then, remove the end-cap at the top of the

WORKABOUT PRO.

•Slide the SW1401 switch to the left to shut off internal battery power.

•Remove the back plate from the unit.

A scanner flex cable is already attached to the WORKABOUT PRO. You need to connect the flex cable to the internal scanner module.

•Remove the adhesive tape which holds the flex cable in a folded position.

•Insert the flex cable into the connector on the scanner module. If necessary, use pincers to hold the flex cable.

Scanner	Connector
Module	Flex
	Cable

Figure 8.9 Attaching The Flex Cable To The Scanner Module

268Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual