Psion Teklogix 7525 user manual Enabling The SE 923HP Scanner

Chapter 8: Expansion Modules

Enabling The SE 923HP Scanner

The SE 923HP scanner (model # WA9002) is the internal scanner module available with the WORKABOUT PRO. To install it:

•Remove the battery. If your unit is using AC power, disconnect it.

•Remove the stylus and then, remove the end-cap at the top of the

WORKABOUT PRO.

•Slide the SW1401 switch to the left to shut off internal battery power.

•Remove the back plate from the unit.

A scanner flex cable is already attached to the WORKABOUT PRO. You need to connect the flex cable to the internal scanner module.

•Remove the adhesive tape that holds the flex cable in a folded position.

•Insert the flex cable into the connector on the scanner module (refer to Figure 8.9 on page 268). If necessary, use pincers to hold the flex cable.

•Fit the scanner module over the back of the WORKABOUT PRO—it replaces the back plate of the unit.

•Fasten the module in place with the screws provided. Tighten the screws to a torque of 3 lbs-in (3kgf-cm), or until finger tight.

•Slide the SW1401 power switch to the right to turn power back on, and replace the end-cap and battery. Tighten the end-cap screws to a torque of 3 lbs-in (3kgf-cm), or until finger tight

8.1.7.1Enabling The SE 923HP Scanner

•Simultaneously, press and hold down the <BLUE> <ENTER> and left <SCAN> keys for a minimum of 6 seconds. A Command> prompt is dis- played on the WORKABOUT PRO screen.

•Type s to display the Scanner> prompt. A list of supported scanners is dis- played.

•Type 3 and press <ENTER> to activate scanner type SE 923HP.

•At the Command> prompt, type 1 (one) to reboot the unit to Windows Mobile 2003 SE.

270Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual