Psion Teklogix 7525 user manual Installing a GSM/GPRS Module

Chapter 8: Expansion Modules

Installing A GSM/GPRS Module

•Apply gentle downward pressure to securely seat the card in the connector.

Insert the PCMCIA card as shown here, with the label facing you.

Figure 8.5 Inserting A PCMCIA Card

•Align the mechanical stop and use the four screws provided to secure in place. Tighten the screws to a torque of 2 lbs-in (2 kgf-cm), or until finger-tight.

•Slide the SW1401 switch to the right to turn power back on.

•Replace the end-cap.Tighten the end-cap screws to a torque of 3 lbs-in (3kgf- cm), and replace the back plate and battery.

8.1.5 Installing A GSM/GPRS Module

Warning:	The installation of this GSM/GPRS module must be performed
	using the appropriate anti-static devices. If unavailable, discharge
	static from your body by touching a grounded metallic object
	before opening any covers on the unit.

The GSM/GPRS module (model # RA3010) accommodates a GSM radio, a SIM card (sold separately) and is equipped with a built-in antenna, which also acts as a mechanical stop for the CF card. The module snaps onto the expansion connector on your WORKABOUT PRO.

Important: Backup any data in RAM first, since it will be erased when the unit is turned off.

•Remove the battery. If your unit is using AC power, disconnect it.

Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual 265