Psion Teklogix 7525 user manual Installing The Antenna

Chapter 8: Expansion Modules

Installing A GSM/GPRS Module

•Fit the antenna at the top of the unit making certain that the antenna contacts are aligned with the contacts on the GSM/GPRS module (see Figure 8.7). Ensure that the tab at the top of the antenna is inserted under the lip of the WORKABOUT PRO’s black plastic frame (Figure 8.8).

•Use the screws provided to secure the antenna on the metal frame. Tighten the screws to a torque of 2 lbs-in (2 kgf-cm, or until finger tight.

Tab

Antenna

Antenna Contacts

GSM/GPRS Module

Figure 8.7 Installing The Antenna

GSM/GPRS Module with SIM Card Stopper Plate in place

Antenna

Scanner Flex Cable

Location of Antenna Tab tucked beneath unit frame

Figure 8.8 An Installed GSM/GPRS

•Slide the SW1401 switch to the right to turn power back on.

•Replace the end-cap.Tighten the end-cap screws to a torque of 3 lbs-in (3kgf- cm), and replace the back plate and battery.

•Verify the installation by turning on the unit and checking that the signal strength icon is available in the taskbar, or that “Expansion Slot - Psion Tek- logix GPRS” is listed under Properties, in the Control Panel System Properties menu.

Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual 267