￿

A – Command Line Interface

Set Config Command

 

 

 

 

The following is an example of the Set Config Zoning command.

SANbox2 $> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config zoning

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the default value.

If you wish to terminate this process before reaching the end of the list

press

’q’ or ’Q’ and

the

ENTER key

to do so.

AutoSave

(True / False)

[True]

Default

(All /

None)

[All

]

Merge

Mode

(Brocade /

SW2)

[SW2

]

Finished configuring attributes.

This configuration must be saved (see config save command) and activated (see config activate command) before it can take effect. To discard this configuration use the config cancel command.

59022-03 D

A-29

Page 119
Image 119
Q-Logic 59022-03 D manual Following is an example of the Set Config Zoning command