A – Command Line Interface | |
Set Port Command | |
|
|
|
|
Set Port Command
Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. This command also clears port counters.
Authority Admin
Syntax set port [port_number] bypass
clear enable
speed [transmission_speed] state [admin_state]
Keywords [port_number]
Specifies the port. Ports are numbered beginning with 0.
bypass
Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address (ALPA) or to all ALPAs on the arbitrated loop.
clear
Clears the counters on the specified port.
enable
Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the following port speed values:
1Gb/s
One gigabit per second.
2Gb/s
2 gigabits per second.
Auto
The port speed is automatically detected.
state [admin_state]
Specifies the administrative state for the specified port. Choose one of the following port state values:
online
Places the port online.
offline
Places the port offline.
diagnostics
Prepares the port for testing.
down
Disables the port.
