Q-Logic 59022-03 D manual Table A-1. Commands Listed by Authority Level

￿	A – Command Line Interface
	Commands

A.3

Commands

The command set provides for User and Admin authority levels.

■User authority grants viewing access to the fabric and switches using the Show command and other read-only commands.

■Admin authority includes the User authority and grants permission to use the Admin command. The Admin Start command opens an admin session which provides access to the commands that change switch and fabric configurations. Refer to the ”Admin Command” on page A-4.

Note: Admin authority is enforced only if fabric security is enabled on the switch. By default, fabric security is disabled. Refer to the System keyword of the ”Set Setup Command” on page A-34for information about setting fabric security.

The commands and their page numbers are listed by authority level in Table A-1.

Table A-1. Commands Listed by Authority Level

User Authority Commands		Admin Authority Command
Date	(A-9)	Admin		(A-4)
Help	(A-11)
		Admin Session Commands
History	(A-12)
Ps	(A-16)
		Alias1		(A-5)
Quit	(A-17)
		Config1		(A-7)
Set Beacon	(A-23)
		Fallback		(A-10)
Show	(A-39)
		Image		(A-13)
Show Config	(A-48)
		Lip		(A-14)
Show Log	(A-50)
		Passwd		(A-15)
Show Perf	(A-52)
		Reset		(A-18)
Show Setup	(A-53)
		Set Alarm Clear		(A-22)
Uptime	(A-58)
		Set Config		(A-24)
Whoami	(A-61)
		Set Log		(A-30)
		Set Port		(A-33)
		Set Setup		(A-34)
		Set Switch		(A-38)
		Shutdown		(A-55)
		Test		(A-56)
		User1		(A-59)
		Zone1		(A-62)
		Zoneset	1	(A-65)
				(A-67)
		Zoning1

1Some keywords are available with User authority outsiide of an admin session.

59022-03 D A-3