Q-Logic 59022-03 D manual Set Setup Command, Set setup, Snmp System

A – Command Line Interface	￿
Set Setup Command

Set Setup Command

Changes SNMP and system configuration settings. The switch maintains one SNMP configuration and one system configuration.

Authority	Admin
Syntax	set setup
	snmp
	system
Keywords	snmp
	Prompts you in a line-by-line fashion to change SNMP configuration settings.
	Table A-9describes the SNMP fields. For each parameter, enter a new value or
	press the Enter key to accept the current value shown in brackets.
	Table A-9. SNMP Configuration Settings
	Entry	Description
	Contact	Specifies the name of the person to be contacted to respond
		to trap events. The default is undefined.
	Location	Specifies the switch location. The default is undefined.
	Trap [1-5] Enabled	Specifies whether traps (event information) are enabled or
		disabled (default).
	Trap [1-5] Address	Specifies the IP address to which SNMP traps are sent. The
		default is 127.0.0.1.
	Trap [1-5] Port	Specifies the port for which SNMP traps are sent.
	Trap [1-5] Severity	Specifies the severity level to use when monitoring trap
		events. The default is Warning
	ReadCommunity	Read Community Authentication. A write-only field; the
		value on the switch and the SNMP management server
		must be the same.
	WriteCommunity	Write Community Authentication. A write-only field; the
		value on the switch and the SNMP management server
		must be the same.
	TrapCommunity	Trap Community Authentication. A write-only field; the value
		on the switch and the SNMP management server must be
		the same.
	AuthFailureTrap	Specifies the IP address where a notification is sent in the
		event of an authentication failure.

A-34 59022-03 D